The Midget Register :: A-series gearbox bell housing pattern

Viewing 1 to 2 (2 Total) A-series gearbox bell housing pattern
speedysaab Total Posts: 1 Joined: August 30, 2018	Hi, I am hoping someone might be able to help me! Im want to make up an adapter plate to fit onto my Toyota T50 gearbox that has a 1275 A-series bell housing on. Its to mate to a Nissan engine. Im therefore looking to find a schematic for the A-series gearbox mounting bolt bell housing pattern on the back of the A-Series engine relative to the crank centreline - would anyone have or know where I might find this data? This would save me loads of time measuring so would be very much appreciated! Thanks Robert Tags: Posted on August 30, 2018 at 7:45 AM

stevec Total Posts: 103 Joined: May 13, 2012	Re: A-series gearbox bell housing pattern Hi Robert, not seen anything. Although is it actually of any use as you may not have the bellhousing in the same location as it would be on a midget engine / gearbox. In fact I would guess the crank center is more likely to be in a different position, so a mock up could be the only way to go to get your crank alignment correct. regards, Steve Posted on September 30, 2018 at 6:28 PM

Viewing 1 to 2 (2 Total)

A-series gearbox bell housing pattern

speedysaab

Total Posts: 1

Joined: August 30, 2018

Hi, I am hoping someone might be able to help me!

Im want to make up an adapter plate to fit onto my Toyota T50 gearbox that has a 1275 A-series bell housing on. Its to mate to a Nissan engine.

Im therefore looking to find a schematic for the A-series gearbox mounting bolt bell housing pattern on the back of the A-Series engine relative to the crank centreline - would anyone have or know where I might find this data?

This would save me loads of time measuring so would be very much appreciated!

Thanks
Robert

Tags:

Posted on August 30, 2018 at 7:45 AM

stevec

Total Posts: 103

Joined: May 13, 2012

Re: A-series gearbox bell housing pattern

Hi Robert, not seen anything. Although is it actually of any use as you may not have the bellhousing in the same location as it would be on a midget engine / gearbox. In fact I would guess the crank center is more likely to be in a different position, so a mock up could be the only way to go to get your crank alignment correct.

regards,
Steve

Posted on September 30, 2018 at 6:28 PM